Skills in the Use of fully Automatic Thread Winding Machine

It is not difficult to operate the automatic thread winding machine. In the process of operating the automatic winding machine, it is necessary to know how to set three important winding parameters: the winding position, the enameled wire specification and the winding width.

The specific method is as follows:

1. Setting of winding position

What is the winding position? Simply speaking, it is the starting point of the winding on the skeleton. This position is closely related to the coil's head and coil type. The specific value of the relevant winding position can usually be measured by the measuring function of the equipment control system. Personnel can also measure it manually. Use the fixed point as the reference point to actually measure with the ruler. When setting this point, pay attention to the winding direction of the coil.

2. Setting of enameled wire specifications

Our common enameled wire has different wire diameters. The correct setting of the enameled wire line will directly affect the effect of the wire. The use of different materials of the enameled wire requires different wire diameter correction values. The copper wire is not easy to be thinned, and the correction value is added 0.02 or so. The aluminum wire is easily stretched after passing through the tension of the winding device and the wire passing device, and the correction value is larger than 0.02-0.2.

3. Winding width setting

The definition of the winding width is the distance from the position where the winding starts to the end position of the winding. Usually, this value directly reflects the length of the winding that the skeleton needs to be wound. When setting, it is necessary to consider the small deformation amount of the skeleton to be used. The minimum value should be taken as the winding width by means of a comprehensive measurement.